Tsys Menu - Radio Shack 20-106 User Manual

Menu Reference
TGRP Options
Parameter
LED Mode Solid or
Flash
LED Color 0-7
Latch LED On or Off
Backlight On, Off or
Flash
Alarm None,
Chirp,
Hi-Lo,
Alert,
Ring,
2-Chirp,
Fast
Hi-Lo,
DTMF#
Fav Yes or No
Skywarn Yes or No
EXPERT BELOW
Delay On or Off
Description
Controls whether the Alert
LED flashes or remains on solid
when the Alert LED is used.
Sets LED color to 0-7 as
defined in the GLOB menu.
By default, 0=LED Off, 1=Red,
2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Normally the Alert LED is active
only while the object is receiv-
ing a transmission. When Latch
is on, the Alert LED will remain
lit after the transmission is com-
plete, unless overridden by a
subsequent object that is also
using the Alert LED.
Controls whether the backlight
should be on, off or flashing
while the object is active.
Sets the Audible Alarm for the
TGRP object. When an Audible
Alarm is selected, the selected
alarm will play at the beginning
of each transmission on the
TGRP object, or anytime the
scanner stops for activity on the
TGRP object while scanning.
When On, the TGRP object is a
member of the Favorites Scan
List.
When On, the CONV object is
a member of the Skywarn Scan
List.
Controls whether a Delay is
used to wait for reply traffic af-
ter a transmission on the TGRP.
112
TGRP Options
Parameter
Delay Time 1-250 x Sets the amount of time (in 100
100 ms millisecond intervals) for the
wait for reply delay if Delay is
On, e.g., 20=2 seconds.
AudioBoost On or Off Applies a 6 dB boost to audio
levels when the object is active.
Hit Count Numeric Increments each time a trans-
value mission is received on the
TGRP object. Global "Hit
Counts" must be set to ON.
Press the
to 0.

TSYS Menu

The TSYS menu is used when creating new
Trunking System objects, or editing existing
Trunking System objects.
TSYS Options
Parameter
Type MOT Sets the trunking system type.
800/900, Choose MOT 800/900 if the
system is a Motorola 800 or 900
MOT
MHz analog or digital trunked
VHF/UHF,
radio system that uses the 3600
P25 baud control channel. Use
MANUAL, P25 AUTO for most Project
25 systems that send channel
P25
table information over the sys-
AUTO,
tem control channel. Use P25
EDACS MANUAL if it is necessary to
STD, manually set the channel table
information or if you wish to use
EDACS
the default 800 MHz table data.
NAROW,
Use EDACS STD for most 800
LTR MHz EDACS systems using the
9600 BPS EDACS control chan-
nel. Use EDACS NAROW for
most 900 MHz and some VHF/
UHF EDACS systems using the
4800 BPS EDACS control chan-
nel. Use LTR for Logic Trunked
Radio (LTR) systems.
Menu Reference
Description
Dflt
softkey to reset
Description
113