[Network Diagnostic Fl Owchart For Ipv6 ] - Aiphone IS SERIES Setting Manual

[Network diagnostic fl owchart for IPv6 ]
Select either
Flow 1
selected fl ow.
Do you have a router that supports stateless address autoconfi guration in the network?
Flow 1
(IP host unit: A static IP address is set,
IP client units: IP addresses are assigned
automatically by stateless address
autoconfi guration)
Be sure to make the following settings on the IP client units
before starting the network settings.
Connect the IP unit and the PC used for settings
directly, and then turn them on. After a while, access
"https://192.168.0.40/" from the browser on the PC. (→P. 20)
NOTE:
When connecting a PC to the IP unit directly, use an Ethernet
crossover cable.
Make the [Network setting: Individual] settings on the IP
unit. (→ P. 22)
* Set "IP version" to "IPv6".
Set it as "Client unit".
*
Enter the IP address of the IP host unit.
*
If you do not know the IP address of the IP host unit, enter
an address (e.g., "fdc2::7000") that has not been assigned
to any other device.
Select "Stateless Address Autoconfi guration" for acquiring
*
IP addresses.
Update the system at [Updating the system]. (→ P. 40)
NOTE:
If you connect a PC master station (IS-SOFT) to the network, install the software (IS-SOFT) to a PC before connecting it to the network.
If you communicate with remote sites (calling, call transferring, paging, etc.), make the remote site connection settings (→P. 18)
after the network settings for your site are complete.
14
or from the chart below, then start the network settings by following the
Flow 2
YES
(Log in.)
Go to P. 15.
START
Flow 2
(All units: Static IP
addresses are set)
NO
Go to P. 16.