Maintenance - One Stop Gardens 93358 Owner's Manual

Transparent Panel Installation Instructions
Note: Remove the protective film from both sides of each panel before installing it.
1. Panel Clips (53) are used to secure the Transparent Panels in place on the
Greenhouse, their locations are marked with X on the facing page.
2. The Roof Panels (60) and the Roof Window Panel (59) will need to be placed as shown
in the insets on the facing page. The top edges of these panels need to be placed up
under the edge of the Crown (10, 11) or the Window Support Beam (42).
3. The Panel Connectors (52) are used to connect the Rear Top and Center Panels (56, 57) to the top of the Wall
Panels (58) in the rear of the Greenhouse. Refer to the locations marked with O and the inset on the facing page.
4. One at a time, place each Transparent Panel (55 – 64) in its proper location on the Ceiling and Frame of the
Greenhouse. Then, secure the Transparent Panel in place, using the quantity and location of Panel Clips (53).
5. To attach Panel Clips,
see illustration and instructions below:
A) Place the two loose ends of the Clip into the groove in the frame
B) Swing the center portion of the Clip up against the Panel
C) Two edges of the Clip swing under the edge of the panel and the center edge holds the panel in place.
Be careful, Panel Clip (53) ends may be sharp and may spring back!
Use and Maintenance
1. BEFORE EACH USE, inspect the general condition of the Greenhouse. Check for loose screws, misalignment or
binding of moving parts, cracked or broken parts, and any other condition that may affect the safe operation of the
Greenhouse. If a problem occurs with the Greenhouse, have it corrected before further use.
Do not use damaged equipment.
2. TO CLEAN: Wipe with a damp cloth, using a mild detergent.
Do not use cleaners that are combustible, corrosive, or not compatible with aluminum.
3. WHEN STORING: Keep the Greenhouse in a box and in a clean, dry location.
Item 93358 For technical questions, please call 1-800-444-3353. Page 29