One Stop Gardens 93358 Owner's Manual page 15

Ceiling Plate Installation Instructions
1. Insert one Normal Bolt (65) through the Corner
Bracket (49) and the upper hole in the Corner Post
(7) at both front corners of the greenhouse, from
the inside out, as shown above. This is for the later
attachment of the Front Ceiling Plate (24-27).
49
(Front)
79
(View from inside greenhouse.)
2. To attach one end of a Side Ceiling Plate (12, 13):
a. Remove the Nut (67) where the Side Diagonal
Strut (80) connects to the Corner Post (7) in
one corner, marked A in the illustration above.
b. Temporarily disconnect that
Side Diagonal Strut (80) from the
Brace Bolt (66), but leave the Bolt in place.
c. Orient the gutter opening up as shown above.
d. Place the Side Ceiling Plate (12, 13) then
the Side Diagonal Strut (80) on the end of
the Bolt, and secure with a Nut (65).
3. Secure the other end of that
Side Ceiling Plate (12, 13) similarly.
Item 93358
12
80
(Left)
7
For technical questions, please call 1-800-444-3353.
4. Attach the Front Ceiling Plate (24, 25)
to the 2 Normal Bolts (65) put in
place in step 1 on the outside of the
greenhouse, note orientation at right.
5. Attach the remaining Side Ceiling Plate (12, 13)
along the other side according to steps 2 & 3,
with the gutter opening up.
31
6. Bolt 2 Post Connectors (48) to a Rear Brace (31)
using Brace Bolts (66) through their bottom holes,
from the outside in. Place Post Connectors
on the outside of the greenhouse with the
flat side against the Brace, as shown above.
Only finger tighten for now.
7. Swing the Rear Braces (31) together and bolt the
second Brace to the second from bottom holes on
the Post Connectors (48), using Brace Bolts (66)
from the outside in. Only finger tighten for now.
Note: The Rear Braces (31) will be under tension.
8. If you cannot attach the second
Post Connector (48), or if they are not parallel:
Make sure that the arrows on both
of the Rear Braces (31) are pointing
towards the Corner Posts (7).
31
(View from
inside
greenhouse.)
Page 15