Crown Beam; Left-Handed Crown Beam 5' 10" 2 - One Stop Gardens 93358 Owner's Manual

Gable and Crown Installation Instructions
Note: Leave Bolts (65) finger tight
until step 5 of this phase.
1. Use 1 Normal Bolt (65) each to attach the
Front Gable Posts (20-23) to the outside top of
the Front Ceiling Plates (24, 25) in the positions
shown on facing page. The bottoms of the 2 outer
Front Gable Posts (22, 23) will be secured using
the Normal Bolts (65) already in place. The sloped
ends of the Posts must be on the top and slant
upward toward the center of the greenhouse.
2. Insert 2 Normal Bolts (65) into the slot in
each Rear Gable Post (18, 19), and use
those Bolts to attach them to the top 2 holes
of the Post Connectors (48) on the outside.
Once again, the sloped ends of the Posts must
be on the top and slant upward toward the center
of the greenhouse. The bottoms of those Rear
Gable Posts (18, 19) must be pressed down
flat against the tops of the Side Posts (14).
Note: The only difference between Right- and
Left-Handed Crown Beams is the location of the holes.
The Beam edges with 3 drilled holes should
align with the Side Ceiling Plate (12, 13) and
the edges with 4 holes should point down.
3. Attach the Right- and Left-Handed Crown Beams
(8, 9) to the Greenhouse using 5 Normal Bolts (65)
for each Beam. The angled edges should meet at
the top of the roof. The Beams are placed on the
outside of the Ceiling Plates (12, 13) and the Corner
Brackets (49) and on the inside of the Posts (16-23).
4. Assemble the Front Crown (11) to the brackets on
the Rear Crown (10) using 6 Normal Bolts (65).
Item 93358 For technical questions, please call 1-800-444-3353.
5. Press the Crown Beams (8, 9) down against
the tops of the Posts (16-23) while tightening
all Bolts (65) to secure them in place.
Crown (10, 11)
Right-handed

Crown Beam (8)

(View from underneath.)
6. With assistance, raise the completed Crown (10, 11)
up underneath the tops of the Crown Beams (8, 9),
and bolt it in place on each end to the bottom of the
Beams using 2 Normal Bolts (65) as shown above.
7. Attach an End Cap (72) to the top outer
corner of each Crown Beam (8, 9).
Left-
handed
Crown
Beam (9)
Page 21