One Stop Gardens 93358 Owner's Manual page 23

Rafter and Brace Installation Instructions
Note: All Rafters (15) require extra Bolts to
be inserted into their slot before assembly.
The small numbers under the main part
number on the facing page are the type and
number of hardware in the order they are
inserted from the TOP of the Rafter.
See the examples below:
Rafter Part
15
66(x2)
Inserted Bolt
Part Numbers
Meaning: Insert 2 Brace
Bolts (66) into the top of
this Rafter (15) before
attaching it to the frame.
1. Insert the required Bolts (See note above
and illustration on facing page) into the
slot in one of the Rafters (15).
2. Attach the Rafter (15) to the Ceiling Plate (12,
13) and the Crown (10, 11), using Normal
Bolts (65) in the slot or using the Bolts (65)
already in place for the center Rafters.
3. Make sure the Rafter (15) is completely seated over
the Normal Bolts (65) on each end before tightening.
4. Repeat above steps for all 10 Rafters (15).
Item 93358
Number
15
66,66,65
Meaning: Insert 2 Brace
Bolts (66), then a
Normal Bolt (65) into
the top of this Rafter
(15) before attaching
it to the frame.
For technical questions, please call 1-800-444-3353.
5. Connect 4 Side Braces (30) onto the underside of the
roof as shown on the facing page, with the arrows
pointing towards the Crown Beams (8, 9). Secure
in place using Brace Bolts (66) at the Crown Beam
and the inserted Brace Bolts (66) in the remaining
holes. Finger tighten first and install the Braces so
that they are touching, side-by-side as shown.
50
(View from underneath.)
6. Using 2 Window Screws (71) each, attach a
Window Stop (50) on the flat side of each Window
Support Beam (42) with its tab pointing away
from the bolt slot openings, as shown above.
15
65
(View from underneath.)
7. Place one of the bolt slots on a Window Support
Beam (42) over one of the inserted Normal Bolts
(65) and swing it over the inserted Normal Bolt (65)
on the other Rafter (15) as shown in the diagram
above. Note that the Window Stop (50) and flat side
of the Window Support Beam (42) are both facing the
inside of the greenhouse. Thread Nuts (67) onto the
Normal Bolts (65) and finger tighten them for now.
42
to Crown (10, 11)
42
65
30
Page 23
15