Floor Plate - One Stop Gardens 93358 Owner's Manual

Post Installation Instructions
Note: All Posts (14, 16, 17) in this
phase require extra Bolts to be
inserted into their slot before
assembly. The small numbers
under the main part number on the
facing page are the type and
number of hardware.
See the examples below:
Post Part Number
17
66(x2)
Inserted Bolt
Part Numbers
Meaning: Insert 2 Brace
Bolts (66) into the
Rear Right Post (17)
before attaching it.
1. Loosen a Bolt on one of the Side Floor
Plates (3,4) in an attachment location
as shown. Slide the slot in a Side Post
(14) over the head of that Bolt.
2. Insert the required Bolts (See note
above and illustration on facing page)
into the slot in the Side Post.
3. Attach the top of the Side Post (14) to
the Ceiling Plate (12, 13), using a Normal
Bolt (65) in the slot or using the Bolt
already in place for the center Post.
4. Repeat above steps for all 10 Side Posts (14)
on the left and right sides of the greenhouse.
5. Slide a white Bushing (81) over all 4
inserted Double Brace Bolts (78). Place
the center hole of each Side Diagonal
Strut (80) over the end of each Double
Brace Bolt and secure with a Nut (67).
6. Loosen a Bolt on the Rear Floor Plate
(5, 6) in a location that a Side Post (14)
attaches, and slide a Side Post over
the head of that Bolt. Insert 4 Brace
Bolts (66) into the slot of that Post.
Item 93358
14
66,78,66
Meaning: Insert a Brace
Bolt (66), then a Double
Brace Bolt (78), then
another Brace Bolt (66)
into this Side Post (14)
before attaching it.
For technical questions, please call 1-800-444-3353.
(View from outside greenhouse.)
7. Remove the 2 Brace Bolts (66) connecting
the Post Connector (48) near that Side
Post. Slide the heads of those Bolts into the
Side Post and insert them through the Post
Connector. Align the top of the Post with the
center of the Connector as shown above, and
press it in place. Reattach the Rear Braces
(31) to the Brace Bolts (66) and secure them.
8. Repeat steps 6 & 7 for another Side
Post (14) and Post Connector (48).
9. Loosen the Bolts (66) where the Rear
Diagonal Struts (79) connect to the Rear Floor
Plate (5, 6). Slide the slot in the Rear-Left
Post (16) over the head of the left Bolt and
the Rear-Right Post (17) over the right Bolt.
10. The slanted ends of the Posts must be
on top and slant towards the center of
the greenhouse. Retighten the Bolts.
11. Slide 2 Brace Bolts (66) into the slot
of each Rear Post (16, 17).
12. Slide one more Brace Bolt (66) into the top
of each Rear Post. Attach the Rear Posts
to the Rear Braces (31) using those Bolts.
13. The frame should now rest square. Measure
diagonally from corner to corner at the top. If
the measurements are not equal, adjust the
frame as needed until square. Some Nuts
(67) may need to be loosened to adjust the
frame. Tighten all Nuts after adjustment.
31
31
14
Page 17