One Stop Gardens 93358 Owner's Manual page 27

Door Assembly and Installation Instructions
Parts in this phase are fastened using
8 Normal Bolts (65), 8 Nuts (67),
and 40 Door Screws (70).
Note: The Door Screws (70) thread directly
into the round portions in the center of the
door frames.
Leave all Screws slightly loose until
the door is mounted on the rail.
1. Place the Side Door Frame (33) with the
rubber flap down. Attach
three Center Door Frames
(36) to the Side Door Frame
(33). Assemble them with
the rounded portion facing
the front (away from the
flap), as shown to the right.
2. Using 2 Normal Bolts (65) and 2
Nuts (67), attach the Door Slider
(34) to the Top Door Frame (35)
oriented as shown to the right.
3. Attach the Top Door Frame (35) to the Side
Door Frames (33) with the Door Slider (34) at
top and the rounded portion facing the front.
(view from behind)
4. Insert a Door Bottom Slider (51) into each end
of the Bottom Door Frame (37). Make sure
that the Sliders are assembled the correct
way, with the gap facing the back of the door –
see diagram. Attach the Bottom Door Frame
(37) to the Side Door Frames (33) using 2
Screws (70) on each side – the one on the
top into the Bottom Door Frame (37) and the
bottom one into the Door Bottom Slider (51).
Item 93358
34
35
For technical questions, please call 1-800-444-3353.
5. Remove the protective film from both
sides of four Door Panels (64). Slide
the Door Panels into the door between
the Door Frame (35-37) pieces.
6. Attach the other Side Door Frame (33) to the
Center Door Frames (36) in the same way.
1a
(side view)
7. Raise the assembled Door up and insert
the first roller of its Door Slider (34) onto
the Door Rail (26, 27). Carefully align the
first Bottom Door Slider (51) over the edge
of the Front Floor Plate (1a, 2a) – see
illustration above. Carefully slide the door
over and align the other top Roller and
bottom Slider as you did the first ones.
8. Assemble and install the second door
by following the previous steps.
9. Once both doors are installed,
tighten all Door Screws (70).
10. Install a Normal Bolt (65) and Nut (67) into the
hole on the end of each Door Rail (26, 27),
and in the hole on the end of each Front Floor
Plate (1a, 2a) to prevent the doors from sliding
off the rails. Attach the Left and Right Rail End
Caps (74,75) onto the ends of the Door Rails.
33
51
Page 27