Kodak NovaJet 850 Training Manual page 39

NovaJet 800 Series Training Guide
Rigid media should be stored laying down on a flat surface. Storing media vertically will
damage the media and cause a media deviation. Damaged media, due to shipping,
should be returned to the source. Warped media will not feed properly through the
NovaJet 880. Refer to acceptable media deviation standards as outlined in the Quick
Start Guide. All calibrations must be performed on the new media to ensure printing
accuracy, including Paper Axis Test, Color Deadband and Color Calibration. Please use
the proper Print Gap specifications to ensure printer head strike does not occur:
Photogloss, Semigloss or other thin media = .059 (.149 cm)
Canvas or Art Paper media = .093 (.236 cm) to .100
FoamCore, Coroplast or Sintra media = .093 (.236 cm) to .100
Bond or Textile = .125 (.317 cm) or slightly
higher
Select: Utility Menu
Calibration Menu
Media Sensor
Media Sensor Adjust
3. Rigid Media Operational Note: Roll Mode/Feeder Stop Mode
A. The Roll mode (take-up is default) should only be used to load rigid media. The
Sheet mode will advance media out of the printer at the end of a print job, possibly
causing damage to the print.
Select: – choose and press Ok.
Setup Menu – Paper Option Menu – Supply Type Roll
B. The Feeder Stop mode (default) must be changed to Normal or the printer will think it
is out of paper after 15 seconds of operation. Symptoms include 3 audible beeps and
the asterisk on the control panel display changes to a minus sign.
Select:
Feed Media Menu - End of
- choose and press
Media Normal
Ok. It is strongly suggested to
save this to a user setting (user 1)
for all future operations.
4. Operational Note: Initial Power Up Sequence
During a printer installation and the new cartridges are installed the message
'Initializing.....' will be displayed on the printers control panel display for up to 5 minutes.
The printer is adjusting the cartridges to the optimum temperature depending on the ink
type loaded. This message
cannot be bypassed during this
period, when the main menu
appears the printer is ready for
normal operation.
39