AT&T TL7600 User Manual page 37

Appendix
Troubleshooting
My calls cut in and out while I'm using my cordless headset.
• Other electronic products such as HAM radios and other DECT
phones can cause interference with your cordless headset.
Try installing your headset as far away as possible from these
types of electronic devices.
• Do not install this headset near a microwave oven or on
the same electrical outlet. You may experience decreased
performance while the microwave oven is operating.
• If your headset is plugged in with a modem or surge protector,
plug the headset (or modem/surge protector) into a different
location. If this doesn't solve the problem, relocate your
headset or modem farther apart from one another, or use a
different surge protector.
• Relocate your headset or telephone base to a higher location.
You may experience better reception by elevating the base.
• If the other phones in your home are having the same
problem, the problem is in your wiring or local service. Contact
your telephone service provider (charges may apply).
The ON/OFF light on the headset is off while charging.
• Make sure the power and line cords are plugged in correctly
and securely.
• Make sure that the battery connector is securely plugged into
the cordless headset.
• Push the headset downwards in the charger until the ON/OFF
light on the headset turns on.
• Unplug the unit's electrical power. Wait for 15 seconds,
then plug it back in. Allow up to one minute for the cordless
headset and headset base or charger to reset.
• Clean the cordless headset and headset base or charger
charging contacts each month using a pencil eraser or cloth.
32