AT&T TL7600 User Manual page 35

Dect 6.0 accessory cordless headset
Hide thumbs Also See for TL7600:
Table of Contents

Advertisement

Appendix
Troubleshooting
You may need a new battery. Please refer to the
Battery charging section on page 8.
Your headset might be defective. Please refer to the
Limited warranty section on pages 45-48 for further
instructions.
I get noise, static, or weak signal even when I'm near the
headset or telephone base.
If you subscribe to high-speed Internet service (DSL - digital
subscriber line) through your telephone lines, you must
install a DSL filter between the telephone line cord and the
telephone wall jack. The filter prevents noise and caller ID
problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
You may be able to improve the performance of your cordless
headset by installing your new headset base farther from any
other existing cordless telephone system.
Other electronic products such as HAM radios and other DECT
phones can cause interference with your cordless headset.
Try installing your headset as far away as possible from these
types of electronic devices.
Do not install this headset near a microwave oven or on
the same electrical outlet. You may experience decreased
performance while the microwave oven is operating.
If your headset is plugged in with a modem or a surge
protector, plug the headset (or modem/surge protector) into
a different location. If this doesn't solve the problem, relocate
your headset or modem farther apart from one another, or use
a different surge protector.
Relocate your headset or telephone base to a higher location.
You may experience better reception by elevating the headset
or telephone base.
If the other phones in your home are having the same
problem, the problem is in your wiring or telephone service.
Contact your telephone service provider (charges may apply).
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents