Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Straight; Paper Is Not Cut - Canon iPF8300S User Manual

Roll paper cannot be inserted into the paper feed slot

Cause
The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.

Cannot load sheets

Cause
The paper source selection is incorrect.

Paper is not cut straight

Cause
The paper is bent or curled at the cut posi-
tion.
Paper rises by the ends of the cut position
before it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
The Cutter Unit is not installed correctly.
The Cutter Unit blade is worn out.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at
an angle.

Paper is not cut

Cause
In the printer driver, No or Print Cut
Guideline is specified in Auto Cut.
In the Control Panel menu, Cutting Mode
is set to Eject or Manual.
The Cutter Unit is not installed.
iPF8300S
Corrective Action
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Corrective Action
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use
scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Reinstall the Cutter Unit correctly.
(See "Replacing the Cutter Unit.")
Replace the Cutter Unit.
(See "Replacing the Cutter Unit.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Install the Cutter Unit.
(See "Replacing the Cutter Unit.")
Roll paper cannot be inserted into the paper feed slot
Troubleshooting > Problems Regarding Paper
→P.1057
→P.1061
Corrective Action
→P.802
→P.1024
→P.1024
→P.928
→P.802
Corrective Action
→P.1024
>
12
1065