Heat & Glo PALOMA-BL Owner's Manual page 27

VALVE
RUBBER
GASKET
REGULATOR
Figure 6.2
11. Using a 3/8 in. (10 mm) nut driver or wrench, remove
the NG orifi ce and replace it with the LP orifi ce pro-
vided in this kit (see Figure 6.3).
Figure 6.3
12. Unscrew the pilot tube fi tting on the pilot and replace
the orifi ce spud with the one included in the conver-
sion kit (see Figure 6.4).
ORIFICE SPUD
PILOT TUBE
ASSEMBLY
Figure 6.4
13. Place the round LP label on the bottom base pan.
14. Reinstall the bottom plate and valve assembly into
15. Reconnect the inlet gas line to the valve assembly
16. Reconnect the electrical power supply.
17. Reconnect the orange wire to the valve assembly.
18. Use a commercially available, non-corrosive leak
19. Reinstall the green wire on the valve.
20. Before reinstalling the burner, ensure that the shutter
Heat & Glo • Paloma • 7031-220 Rev. P • 10/08
Place the propane conversion plate adjacent to the
existing rating plate.
Note: The qualifi ed service agency installing this conversion
MUST enter the day, month, and year, and sign the propane
conversion plate added to the appliance.
the appliance. Reinstall the six hold down screws.
and turn on the gas line valve. Check the incoming
line for leaks.
This will allow for the pilot to turn on with the control
switch in the "ON" position. Check all pilot line con-
nections for leaks. (See Figure 6.4)
check solution to test for leaks around the pilot. Be
sure to rinse off all leak check solution following test-
ing. See Figure 6.4 for leak check points. Extinguish
the pilot.
WARNING
Shock or burn risk.
• Disconnect green wire from gas valve.
Failure to disconnect green wire could result
in severe burns.
setting is fully open. Reattach pilot to pilot shield to
burner (see Figure 6.5). Retighten the screw.
REATTACH REATTACH
PILOT SHIELD PILOT SHIELD
Figure 6.5
27