Heat & Glo PALOMA-BL Owner's Manual page 25

FIG. A 90 DEGREE ELBOW
PLACE MARK WHERE PROTRUDES THROUGH
EXTERIOR WALL TO CUT OFF EXCESS
90° ELBOW
CENTER LINE
PIPE LENGTH
FIG. C MINIMUM CLEARANCE
INTERIOR WALL - 2 IN. (51
MM) CLEARANCE FROM
REAR OF STOVE
CENTER LINE
Snorkel Cap Kit (SLK-SNKD) must be used for horizontal vent runs with no vertical rise.
Figure 5.35
USE HEAT SHIELD / WALL THIMBLE
PIPE LENGTH
TRIM RING
HTI VENT HHW2 PART #841-0670
(RECOMMENDED FOR OPTIMUM PERFORMANCE)
MINIMUM OF 6 IN. (152 MM)
OF PIPE THROUGH THE WALL
WALL THIMBLE
HEAT SHIELD OVER
TOP HALF OF PIPE
TRIM RING
Heat & Glo • Paloma • 7031-220 Rev. P • 10/08
FIG. B 45 DEGREE ELBOW
TRIM RING
45° ELBOW
5 IN. (127 MM) CLEARANCE
FROM APPLIANCE CORNER
HTI VENT HHW2 PART
#841-0670 (RECOMMENDED
FOR OPTIMUM PERFORMANCE)
HEAT SHIELD
OVER PIPE
5 IN. (127 MM) CLEARANCE
FROM APPLIANCE CORNER
TO COMBUSTIBLE WALL
25