Class A Metal Chimney - Heat & Glo PALOMA-BL Owner's Manual

I. Class A Metal Chimney
TERMINATION
CAP PART #SLK-991DA
EXISTING METAL
CHIMNEY SYSTEM
DIRECT VENT
PIPE
Figure 5.20
CAUTION
Ensure that existing chimney is functionally sound and
clean.
• Have inspection done by qualifi ed chimney sweep or
professional installer BEFORE converting to direct vent
appliance.
1. Remove existing chimney cap.
2. Measure the distance from the top of the chimney to
the bottom of the ceiling support box, add 3 in. (76
mm) to this measurement, and cut a section of 4 in.
(101 mm) flex pipe to that length (the flex should be
fully extended).
3. Connect the end of the flex pipe section to the
underside of the top adapter, using four sheet metal
screws (Figure 5.21).
FLEX PIPE
Figure 5.21
20
TOP ADAPTER
FLASHING
4 in. (102 mm)
FLEX PIPE
RETRO CONNECTOR
TOP ADAPTER
SHEET METAL SCREWS
Heat & Glo • Paloma • 7031-220 Rev. P • 10/08
4. Pass the flex pipe down through the center of the
chimney system, and center the top adapter on the top
of the chimney pipe. Drill four 1/8 in. (3 mm) diameter
holes through the top adapter, and into the chimney
top. Ensure that you are drilling into the metal on the
chimney. Twist lock the high wind termination cap onto
the top adapter (Figures 5.22 and 5.23).
Figure 5.22
DRILL FOUR 1/8 IN. (3 MM)
DIAMETER HOLES
Figure 5.23
5. Pull the flex pipe down through the ceiling support box,
until it protrudes approximately 3 in. (76 mm). Connect
the flex pipe to the retro connector, and attach with
sheet metal screws.
6. Push the flex pipe back up into the ceiling support box,
center the retro connector, and attach it to the support
box with sheet metal screws.
7. The connection between the appliance and the retro
connector may be completed with sections of direct
vent pipe.
HIGH WIND
TERMINATION CAP
SHEET METAL SCREWS