Table of Contents
Advertisement
Controlling the AR-3000R from an External Device
Connecting External Equipment
Ports Used in Program Playback
"START": Plays back phrases in the order set in program
playback.
"STOP": This stops phrase playback.
"INC" (Increment): Advances through the program playback
order.
"DEC" (Decrement): Goes back through the previous phrases
in the program playback order.
"EXCHANGE": Advances through the cycle of the Programs
1 through 5 (1-2-3-4-5-1-2...). In this case, playback begins
from the first phrase selected in the program to which you
have switched.
* If no settings are made for Programs 2 through 5, playback
begins from the first phrase set in Program 1.
Set to "ON" by shorting the above-mentioned port and
"COM (common)."
fig.14-16e
Playback
Advance the phrase sequence by one
Make the phrase sequence go back by one
Advance the program sequence by one
Turning the Power On and Off → p. 24
Operational Specifications for
Program Playback
When a one-shot control signal is input from a timer or
similar device, a single registered phrase is played back.
* If there is no registered phrase saved, the next registered
phrase is played back.
When consecutive signals are input, phrases are played back
in succession in the order registered in the program.
90
Common port
Stop
fig.14-17e
START Port
STOP Port
No. 001
AUDIO OUTPUT
No. 001 Interrupted
START Port
AUDIO OUTPUT
Playback:
Input a control signal to the START port.
→ Phrases are played back in accord with the registered
program playback order.
Stop:
Input a control signal to the STOP port.
→ This stops phrase playback.
Advancing in the Playback Sequence:
Input a control signal to the INC (Increment) port.
→ This advances through the program playback order one
phrase at a time.
Going Through the Playback Sequence in Reverse
Order:
Input a control signal to the DEC (Decrement) port.
→ This causes the phrases to go back through the program
playback order one phrase at a time.
Advancing Through Programs 1 Through 5:
Input a control signal to the EXCHANGE port.
→ This advances through Programs 1 Through 5 (1-2-3-4-5-1-
2-...).
Playback begins from the first phrase selected in the program
to which you have switched.
* If no settings are made in Programs 2 through 5, playback
begins from the first phrase set in Program 1.
During phrase playback, even when a new START signal is
input, it is disregarded.
fig.14-18e
START Port
AUDIO OUTPUT
If input of START signals continues when the end of the last
phrase in Program 1 is reached, playback then continues
with the first phrase in Program 1. To advance to Program 2,
input a control signal to the "EXCHANGE" port.
No. 002
No.001
No.002
No.003
Disabled
No. 001
Advertisement
Table of Contents
