Table of Contents
Advertisement
Modifying Recorded Phrases (Phrase Settings)
Converting a Phrase's Recording
Settings (Phrase Convert)
This converts the recording-setting items RDAC-Mode and
recording type to other settings while leaving phrase content
unchanged.
RDAC-Mode (Signal Processing
Format)
• H-LINEAR: 24-bit PCM recording
• LINEAR: 16-bit PCM recording
• MODE3: Approximately 2.5 times the recording time
available with LINEAR
• MODE2: Approximately 2.5 times the recording time
available with LINEAR, or longer
• MODE1: Approximately 4 times the recording time
available with LINEAR
The RDAC mode is converted at times like these.
• When conducting Dual Mono mode (p. 120) two-channel
simultaneous playback (In the Dual Mono mode,
simultaneous playback is not possible unless the phrases
are uniformly RDAC-Mode.)
• When conducting multiple-unit simultaneous playback
with AR-LINK (p. 123) (With AR-LINK playback,
simultaneous playback is not possible unless the phrases
are uniformly RDAC-Mode.)
• When phrases recorded with H-LINEAR or MODE3 on
the AR-3000R are used on the AR-2000 or the like (H-
LINEAR and MODE3 phrases cannot be used
unchanged on the AR-2000.)
Please be aware that conversion to a higher level does not
enhance the sound quality.
Recording Type
• STEREO
• MONO
The recording type is converted at times like these.
• When conducting two-channel simultaneous playback in
the Dual Mono mode (p. 123)(In the Dual Mono mode,
simultaneous playback is not possible unless the phrases
are mono.)
72
• When conducting multiple-unit simultaneous playback
with AR-LINK (p. 123) (With AR-LINK playback,
simultaneous playback is not possible unless the phrases
are of the same recording type.)
<Conversion of a single stereo phrase to a single mono
phrase: STEREO → MONO>
fig.11-22e
Stereo Phrase
One phrase
Phrase 1
You can also convert the recording type in the same way.
<Conversion of a single stereo phrase to two mono phrases:
STEREO → MONO 1, 2>
fig.11-23e
Stereo Phrase
Two phrases
Phrase 1
<Conversion of two mono phrases to a single stereo phrase:
MONO 1, 2 → STEREO>
fig.11-24e
Mono Phrase
Phrase 1
One phrase
Mono Phrase
Phrase 2
Procedure for Phrase Convert
● Converting the RDAC-Mode
1. Press the MODE button.
The MODE indicator lights up.
2. Use the SELECT dial to choose "3.7 Phrase Convert,"
then press the dial.
3. Turn the SELECT dial to choose RDAC-Mode, then press
the dial.
fig.11-g44e
4. Turn the SELECT dial to choose RDAC-Mode type (H-
LINEAR/LINEAR/MODE3/MODE2/MODE1), then
press the dial.
fig.11-g44e
Mono Phrase
Phrase 2
Mono Phrase
(L ch of Phrase 1)
Phrase 2
Mono Phrase
(R ch of Phrase 1)
Phrase 3
Stereo Phrase
Phrase 3
L ch:
Phrase
1
R ch:
Phrase
2
Advertisement
Table of Contents
