Table of Contents
Advertisement
Editing
Display:
Cannot set for
selected phrase.
Situation:
A setting item does not correspond to the
selected phrase.
Action:
Reselect a phrase for which the setting can be
made, or record a new phrase.
MIDI Related
Display:
Buffer overflow
Modify trans.
Situation:
More MIDI data was received in a short time
than the AR-3000R was able to process.
Action:
Change the way in which MIDI data is being
transmitted.
Display:
MIDI Out at THRU
Nothing sent.
Situation:
Because MIDI output is set to THRU, MIDI
data cannot be sent.
Action:
Set MIDI output to OUT.
Display:
No Active Sense
Recording stopped
Situation:
MIDI Active Sense was interrupted.
Action:
Check the status of the transmitter and the
MIDI cable connections.
Display:
MIDI checksum
error.
Situation:
Checksum error found in received MIDI data.
Action:
Check the transmission status and the MIDI
data.
System Related
Display:
Unit overheated.
Let heat escape.
Situation:
The AR-3000R gets hot.
Action:
Ventilate well to avoid overheating, and keep
the unit cool.
Regarding Card Conversion
* Refer to the Card Conversion List (p. 80).
Display:
Card conv. error
Not enough space
Display:
Unconvertible
record setting(s)
Display:
Playback point
is set.
Display:
Unconvertible
pattern phrase(s)
Display:
Cannot convert,
song phrase(s).
Display:
Phr. after No.501
Cannot convert.
Display:
Phrase(s) stored
after No. 501.
Regarding AR-LINK
Display:
PhraseTypesDiffer
Can't sync play
Situation:
The RDAC-Grades, RDAC-Modes, or
recording types of the phrases being played
back on the master and on the slave are
different.
Action:
Make sure the phrases being played back on
the master and the slave have the same RDAC-
Grade, RDAC-Mode, and recording type.
Display:
Phrase not found.
Can't sync playbk
Situation:
Because the phrase specified by AR-LINK does
not exist, synchronized playback is not
possible.
Action:
Specify a phrase that exists on the slave side.
Display:
More than one
AR-LINK master.
Situation:
No more than one AR-LINK master may exist
on a single network.
Action:
Set to "Slave."
Display:
AR-LINK master.
Can't conn. to IN
Situation:
On the device set as the AR-LINK master, IN
cannot be used.
Action:
Do not connect to AR-LINK IN on the device
set as "Master."
Error messages
133
Advertisement
Table of Contents
