Connecting External Speakers - Roland CD-2u Owner's Manual

Connecting External Speakers

You can connect external speakers with built -in amplifier to the LINE OUT jack and use them
to listen to playback from the CD-2u/SD-2u or the sound received at its inputs. If you connect
the LINE OUT jack to the input jack of your digital piano, you'll be able to listen to the sound
using the built-in speakers of your digital piano.
● Once everything is properly connected, be sure to follow the procedure below to turn on
their power. If you turn on equipment in the wrong order, you risk causing malfunction or
equipment failure.
● To prevent malfunction and equipment failure, always turn down the volume, and turn off
all the units before making any connections.
1
Turn off the power of the CD-2u/SD-2u.
* To prevent acoustic feedback, set the [MIC LEVEL] switch to the "MANUAL" position, and then
turn the [MIC] knob all the way to the left so that it's off.
2
Minimize the volume of the external speakers (or digital piano) you'll be
connecting, and turn off the power.
3
Connect the CD-2u/SD-2u's left side panel LINE OUT jack to your external
speakers (or digital piano).
fig.connect-lineout-e.eps
Type of plug that can
be connected
RCA phono type
4
Turn on the power of the CD-2u/SD-2u.
5
Turn on the power of your external speakers (or digital piano).
6
Turn the [VOLUME] knob to adjust the output level of the LINE OUT jack.
Adjust the volume of your external speakers (or digital piano).
You can use external speakers that have a built-in amplifier.
●
Howling could be produced depending on the location of microphones relative to
●
speakers. This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
Note
LINE OUT
L R
Important
To the input jacks of
your external speakers
L R
123