Setting Up The Printer Description; Default Setup - Intermec EasyCoder F2 Installation & Operation Manual

Chapter 6
Setting Up the Printer
Description

Default Setup

34
The setup controls the printer in regard of serial communication,
test and service operations, and specifi es which types of media and
ribbon are loaded in the printer.
Check the list below to see if the printer's default setup matches your
requirements. If not, you will have to change the setup. To enter the
Setup Mode, press the < Setup> key on the printer's built-in keyboard
and follow the instructions in Chapter 7, "Setup Mode."
The printer is, by default, set up according to the list below:
Communication
Baud rate:
Character length:
Parity:
Stop bits:
Protocol:
Test/Service
Testprint:
Data dump:
Memory reset:
Label rest dots:
Form adj dots X:
Form adj dots Y:
Media
Media type:
Paper type:
Label length:
Sensitivity:
Darkness:
Intermec EasyCoder F2 – Installation & Operation IPL Version, Ed. 1
9600 bps
8 bits
None
1 bit
XON/XOFF
n.a.
No
n.a.
0
0
0
Gap
DT
1200 dots
420
0%