Intermec EasyCoder F2 Installation & Operation Manual page 14

Media Compart-
ment, cont.
Intermec EasyCoder F2 – Installation & Operation IPL Version, Ed. 1
Media Supply Positions
There are four sets of slots and threaded holes in the printer's center
section for the media supply roll post or rotating hub (optional).
These slots allow the largest possible roll size to fit, given the
limitations of any liner takeup unit and/or the full enclosure provided
by the long side door. The positions are indicated by numbers
engraved in the center section.
• Position 1 is used when the media compartment is fully enclosed
by a long side door, regardless of the existence of any integral liner
takeup unit. Maximum roll size is 152 mm (6 inches).
• Position 2 is used when the printer has a short side door that only
encloses the print mechanism, but does not have an integral liner
takeup unit. Maximum roll size is 213 mm (8.38 inches).
• Position 3 is used when the printer has a short side door
and an integral liner takeup unit. Maximum roll size is 213
mm (8.38 inches).
• Position 4 is reserved for possible future development.
The printer can also use an external media supply located behind
the printer.
Chapter 2 Installation
Pos. 3
Pos. 2
Pos. 1
(Pos. 4)
13