Media Roll Size - Intermec EasyCoder F2 Installation & Operation Manual

Media Roll Size

Intermec EasyCoder F2 – Installation & Operation IPL Version, Ed. 1
Core
Diameters: 38-40 mm (1.5 inches) or 76.2 mm (3 inches)
Width: Must not protrude outside the media.
The media must be wound up on the core in such a way that the
printer can pull the end free.
Roll
Max. diameter:
- Position 1
- Position 2
- Position 3
Max. width:
Min. width (standard):
Min. width (Quick-Load):
Max. web thickness:
The maximum recommended media thickness is 175µm. Thicker
media may be used, but print quality will be reduced. The stiffness
is also important and must be balanced against thickness to maintain
print quality.
Media rolls to be loaded inside the printer should be wound with the
printable side facing outwards.
The media supply must not be exposed to dust, sand, grit, etc. Any
hard particles, however small, can damage the printhead.
Appendix 2 Media Specifi cations
152 mm (6.00 inches)
213 mm (8.38 inches)
203 mm (8.00 inches)
60 mm (2.36 inches)
25 mm (1.00 inches)
40 mm (1.57 inches)
175 µm (0.007 inches)
65