Power Connector Cable - HP ProBook 5330m Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 650369-001. For
more Cable Kit spare part information, see
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the keyboard (see
7. Remove the fan (see
8. Remove the top cover (see
9. Remove the speakers (see
10. Remove the system board (see
Remove the power connector cable:
1. Position the computer right-side up, with the front toward you.
2. Remove the WWAN and WLAN cables (1) from the routing channels in the base enclosure.
3. Remove the T8 2.5x3.0 screw (2) that secures the power connector bracket to the base
enclosure.
4. Remove the power connector bracket (3) from the base enclosure.
72 Chapter 4 Removal and replacement procedures
Cable Kit on page
Battery on page 37).
Service access cover on page
Keyboard on page
Fan on page 55).
Top cover on page
Speakers on page
System board on page
23.
52).
57).
67).
68).
39).