HP ProBook 5330m Maintenance And Service Manual page 87

5. If it is necessary to replace the webcam module, position the display assembly on a flat surface.
Gently pull the webcam module away from the double-sided tape on the display back cover and
remove the webcam.
6. If it is necessary to replace the display hinges, remove the three T8 2.5x3.0 screws (1) that
secure the hinge covers to the display back cover.
7. Insert a small tool (2) under each hinge cover, and then apply upward pressure to disengage the
hinge cover (3).
NOTE: Be careful not to scratch the silver paint when removing the display hinge covers.
8. Remove the four T8 2.5x4.0 screws on the bottom corners and the two T8 2.5x3.0 screws (1) on
the upper corners of the display hinges that secure the display hinges to the display assembly
back cover.
Component replacement procedures 79