Hard Drive Cables and Connector
Description
Hard drive connector cable
The hard drive connector is secured with two screws and has two cables that connect to the system
board.
Figure 7-19
To remove the hard drive connector:
1.
Prepare the computer for disassembly (see
on page
2.
Remove the rear cover (see
3.
Remove the hard drive (see
4.
Disconnect the hard drive power and data cables (1) from the system board.
NOTE:
on the wires.
5.
Remove two screws that secure the hard drive connector (2) to the computer.
6.
Remove the cables from the metal clips built into the computer.
52
Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Hard drive cable location
34).
Rear Cover on page
Hard Drive on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Preparing to Disassemble the Computer
35).
49).
Spare part number
669997-001