Rear Cover - HP Pro 1005 Maintenance & Service Manual

Rear Cover

Description
Rear cover
Remove the main rear cover to access internal components. The cover is secured by three Phillips
screws – two captive in the bottom corners, one non-captive above the stand.
To remove the rear cover:
1. Prepare the computer for disassembly (see
on page
2. Loosen the captive two Phillips screws (1) that secure the cover to the computer.
3. Remove the non-captive Phillips screw (2) that secures the cover to the computer.
4. Lift the cover off the computer (3).
Figure 7-1
To replace the rear cover, reverse the removal procedures.
34).
Removing the rear cover
Preparing to Disassemble the Computer
Spare part number
669985-001
Rear Cover 35