Hard Drive Cables And Connector - HP 1155 Maintenance And Service Manual

NOTE: Make sure the grommets are not broken or missing before installing the hard drive.
Replacement grommets are available using spare part number 669991-001.

Hard Drive Cables and Connector

Description
Hard drive connector cable
The hard drive connector is secured with two screws and has two cables that connect to the system
board.
To remove the hard drive connector:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the hard drive (see
4. Disconnect the hard drive power and data cables (1) from the system board.
NOTE:
on the wires.
5. Remove two screws that secure the hard drive connector (2) to the computer.
6. Remove the cables from the metal clips built into the computer.
37).
Rear Cover on page
Hard Drive on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Preparing to Disassemble the Computer
38).
59).
Hard Drive Cables and Connector
Spare part number
669997-001
61