Display Panel - HP Pro 1005 Maintenance & Service Manual

Display Panel

Description
Display panel, 18.5-inch, non-ZBD, 200 nits
The display panel is secured to the display bracket with four screws (two on each side). This
procedure continues the previous section that shows how to remove the bezel while removing a
minimum number of components.
To remove the display panel:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the system board cover (see
4. Disconnect the speaker cables from the system board (see
5. Remove the front bezel (see
6. Remove the two screws that secure the display panel to the bracket.
Figure 7-38
7. Remove the two screws that secure the display panel to the bracket.
Figure 7-39
8. Disconnect the two LCD backlight cables from the inverter board.
9. Lift the bracket assembly from the bottom side of the display.
70 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
34).
Rear Cover on page
Front Bezel on page
Removing the display panel screws
Removing the display panel screws
Preparing to Disassemble the Computer
35).
System Board Cover on page
Speakers on page
69).
Spare part number
671542-001
60).
42).