Table of Contents
Advertisement
Table 3-2
Computer Setup—Storage (continued)
DPS Self-Test
Boot Order
10
Chapter 3 Computer Setup (F10) Utility
Allows you to execute self-tests on ATA hard drives capable of performing the Drive Protection
System (DPS) self-tests.
NOTE:
This selection will only appear when at least one drive capable of performing the DPS
self-tests is attached to the system.
Allows you to:
●
Specify the order in which EFI boot sources and legacy boot sources (such as a USB flash
media device, hard drive, optical drive, or network interface card) are checked for a bootable
operating system image. Each device on the list may be individually excluded from or
included for consideration as a bootable operating system source.
●
Specify the order of attached hard drives. The first hard drive in the order will have priority in
the boot sequence and will be recognized as drive C (if any devices are attached).
Press
F5
to disable a device. Press
selected device.
NOTE:
MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating
system has started.
Shortcut to Temporarily Override Boot Order
To boot one time from a device other than the default device specified in Boot Order, restart the
computer and press
F9
before the computer boots to the operating system. After POST is
completed, a list of bootable devices is displayed. Use the arrow keys to select the preferred
bootable device and press Enter. The computer then boots from the selected non-default device
for this one time.
Enter
to select a device. Press the arrow keys to drag a
- Quick Links:
- Memory
Hide quick links:
Advertisement
Table of Contents
