Optical Drive Cables and Connector
Description
Optical drive connector cable
The optical drive connector is secured with two screws and has two cables that connect to the system
board.
Figure 7-14
To remove the optical drive connector:
1.
Prepare the computer for disassembly (see
on page
2.
Remove the rear cover (see
3.
Remove the optical drive (see
4.
Remove two screws that secure the optical drive connector (1) to the computer.
5.
Disconnect the optical drive power and data cables (2) from the system board.
NOTE:
on the wires.
Optical drive cable location
34).
Rear Cover on page
Optical Drive on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Preparing to Disassemble the Computer
35).
45).
Optical Drive Cables and Connector
Spare part number
669998-001
47