Front I/O, Usb Assembly - HP 8200 Elite Series Maintenance And Service Manual

Front I/O, USB Assembly

Description
Front I/O and USB assembly
The front I/O, USB assembly is mounted to the front of the chassis and is removed by pulling it away
from the chassis.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Disconnect the three cables from the following system board connectors:
●
Yellow connector labeled FRONT USB
●
Green connector labeled FRONT USB2
●
Blue connector labeled FRONT AUD
NOTE:
used for the front I/O assembly. See the following image for its location.
(Front Bezel on page
The blue FRONT AUD connector is not located near the other two connectors
(Preparation for Disassembly on page
(Computer Access Panel on page
75).
Spare part number
646821-001
73).
74).
Front I/O, USB Assembly 107