Table of Contents
Advertisement
15 In the Wireless Mode field, select one of the following modes:
802.11g & 802.11b
802.11g only
802.11b only
16 In the 54g Protection field, select Auto to enable 54g protection or Off to disable
the function. The Auto option will use RTS/CTS to improve 802.11g performance
in mixed 802.11g/802.11b networks. Turning the protection off maximizes
802.11g throughput under most conditions.
17 Click Next. The (Setup Wizard 4/4) ----- Wireless Security Settings screen opens.
18 In the Select SSID field, select the SSID from the drop-down list that you want to
use.
19 In the Network Authentication field, select one of the following authentication
methods from the drop-down list:
Open. All devices may access the wireless network (preferred option).
Shared. Only devices configured with the 64-bit or 128-bit Key may access
the wireless network.
WPA-PSK (Wi-Fi Protected Access Pre-Shared Key). Your network is secured
by encryption of all traffic using a pre-shared dynamic key.
20 Do you want to enable WEP Encryption?
If yes, in the WEP Encryption field, select Enabled from the drop-down list.
If no, in the WEP Encryption field, select Disabled from the drop-down list.
21 Click Save/Reboot to save the changes you made. You must reboot the gateway
for the changes to take effect.
4036168 Rev A
Setting Up Your System with the Setup Wizard
25
Advertisement
Table of Contents
