Cisco DDR2200 Series Installation And Operation Manual page 261

Ddr2200 series residential gateway
Table of Contents

Advertisement

4
Click DHCP Server Probing. The DHCP Server Probing screen opens.
5
Select Enable to enable DHCP server probing.
6
Enter the Probing Interval in seconds, or accept the default value if appropriate.
Note: This parameter defines how often the residential gateway communicates
with the default gateway to see if it is still active. The default value is 60 seconds
(1 minute).
7
Enter the Probing Reset Trigger, or accept the default value if appropriate.
Note: This parameter defines the consecutive number of times the default
gateway must fail to respond to probing before a new DHCP lease is requested.
the default value is 15.
8
Click Save/Apply to save your settings.
4036168 Rev A
DHCP Server Probing
239

Advertisement

Table of Contents
loading

Table of Contents