Table of Contents
Advertisement
c
Check the VLAN Mux - Enable Multiple Protocols Over a Single PVC
check box, if applicable.
d In the PPP Username: field, enter the user name for the point-to-point
protocol.
e
In the PPP Password: field, enter the password for the point-to-point
protocol.
f
In the PPPoE Service Name: field, enter the name for the point-to-point over
Ethernet service.
g
In the VPI field, enter the virtual path identifier (VPI). Values are: 0 to 65535.
h In the VCI field, enter the virtual channel identifier (VCI). Values are: 0 to
65535.
i
In the Service Category field, select ABRI Without PCR.
j
Check the Enable Quality of Service check box if applicable.
k In the Authentication Method field, select AUTO.
l
Check Enable NAT.
m Check the Enable IGMP Multicast check box, if applicable.
n Check the Enable WAN Service check box.
7
Click Save to save your settings.
8
Click Reboot. This action reboots the residential gateway so that the WAN setup
configuration takes effect.
Configuring the WAN Interface (MER Broadband Type)
To configure a WAN interface for MAC Encapsulation Routing (MER) broadband
type, complete the following steps.
1
Click Home Network on the main screen. The Client Summary screen opens.
4036168 Rev A
WAN Quick Setup
115
Advertisement
Table of Contents
