Table of Contents
Advertisement
Configuring DSL Master Settings
To configure DSL master settings for the residential gateway, complete the following
steps.
1
Click DSL on the main screen. The Summary screen opens by default.
2
Click the Setting tab. The DSL Slave Settings screen opens by default.
3
Click the DSL Master Settings tab to open the DSL Master Settings screen.
4
Define whether the RG will work on both pairs or a single pair.
Choose Bonding Mode if you want the RG to work on both pairs.
Choose Non-bonding Mode if you want the RG to work on a single pair.
5
Set or clear the PhyR Enable check box depending on whether you want PhyR
enabled.
6
Click Save/Apply to save the settings.
4036168 Rev A
DSL Settings
103
Advertisement
Table of Contents
