Table of Contents
Advertisement
Chapter 5 Home Network Configuration
4
Click the ETH WAN Config tab. The Ethernet WAN Configuration screen opens.
By default, LAN port 4 (eth1.4/LAN4) is chosen as the WAN port, and Ethernet
WAN mode is disabled.
5
Select the appropriate connection mode as follows:
Choose Default Mode if you have only a single service over the WAN
interface (i.e., no VLANs)
Choose VLAN MUX Mode if your service has multiple VLAN services over
one connection.
6
Click Save/Apply to save your selection, and then continue with the appropriate
settings below.
7
Repeat steps 1-6 above for any additional VLAN services that need to be added.
120
4036168 Rev A
Advertisement
Table of Contents
