Table of Contents
Advertisement
1. Turn the computer and the projector on.
IMPORTANT
2. Close all open applications on the computer.
3. Insert the SMART Board software CD into the CD drive.
–
On Windows computers, the installation starts automatically. Follow the on-screen
instructions. If the CD doesn't start automatically, select Start > Run, type x:\autorun.exe
(where x: is the CD drive), and press ENTER.
–
On Macintosh computers, double-click the SMART Board Install CD icon that appears on
the desktop. Double-click the SMART Board Software icon and follow the on-screen
instructions. You may require an administrator's password to complete the installation.
Configuring the Computer Port
After you install SMART Board software and connect the interactive whiteboard, the screen
becomes fully interactive. However, sometimes SMART Board software can't locate the port to
which the interactive whiteboard is connected.
If the screen isn't touch sensitive, configure the port in SMART Board software. If the interactive
whiteboard is connected with a USB adapter, disconnect the USB connector from the computer,
wait ten seconds, and reconnect it. For more information, see the SMART Board software Help.
Orienting the Interactive Whiteboard
Although the interactive whiteboard is oriented by default, you may want to perform an orientation
to ensure that the computer accurately tracks contact with the screen. For more information, see
the SMART Board software Help.
18
If you're using a USB adapter to connect the interactive whiteboard to the
computer and the computer can't find an appropriate driver, unplug the USB
adapter from the computer, install SMART Board software and then reconnect
the USB adapter.
If the Found New Hardware wizard appears, browse to the SMART Board
software CD so that the wizard can locate the correct driver.
Finalizing the Installation
99-00582-20 REV A0
Advertisement
Table of Contents
