Configuring The Com Port For A Serial Connection - Smart Technologies SMART Board Installation Manual

For flat panel displays

Hide thumbs Also See for SMART Board:

Table of Contents

To orient the interactive whiteboard

1. Press the SMART Board icon in the system tray (Windows computers) or in the Dock

(Macintosh computers), and press Orient.

The orientation screen appears.

2. Follow the on-screen instructions, pressing your finger squarely on each target.

NOTE: If you press on the targets out of sequence or inaccurately, a Bad Orientation Point

dialog box appears. Use the mouse to click OK, because touch awareness isn't available.

3. When the orientation screen disappears, test the orientation by moving your finger across the

interactive whiteboard. The pointer should track your finger very closely and appear directly

beneath the center of your fingertip.

NOTE: If the pointer doesn't accurately track your finger, calibrate the digital cameras

(page 32).

To change the orientation level

1. Press the SMART Board icon in the system tray (Windows computers) or in the Dock

(Macintosh computers), and press Control Panel.

2. Press SMART Board Settings.

3. Select Alignment/Orientation Precision from the drop-down list.

4. Press Quick (4 points), Standard (9 points) or Fine (20 points).

5. Press OK.

NOTE: This setting remains in effect for all subsequent orientations until you change the

orientation level again.