Selecting The Projector's Picture Settings; Adjusting The Projected Image - Smart Technologies SMART Board 4000i Installation Manual

Selecting the Projector's Picture Settings

The projectiondesign F20 projector has two picture quality settings. If you turn eco mode off, the
projector displays its brightest image, but this setting also reduces the life of the lamp. To display
an acceptable image without reducing the lamp's life, turn eco mode on.
To select the projector's picture setting
1. Press MENU on the projector's remote control.
2. Select the dynamic menu.
3. Press the remote control's arrow buttons to find and select the eco mode category.
4. Select on or off. The projector's image quality changes to reflect your choice.
5. Press OK on the remote control to return to the main menu, and press menu on the remote
control to exit.

Adjusting the Projected Image

You may need to adjust the projector to display a focused image that fits on the screen. Complete
the following procedures only as required.
NOTE: Don't adjust the image size and geometry based upon the projector's splash screen. The
splash screen image is much smaller than the computer's projected image. Make sure you set the
computer's resolution and refresh rate (see page 13) before you adjust the projected image.
While making adjustments to the projected image, check both the reflection in the small mirror and
the actual image on the screen. For the best image, the reflection must be in the center of the
small mirror, and the gap on each side of the mirror's image must be symmetrical.
Preparing the 4000i
To adjust the projector, you must first remove the rear access panel (see page 7). Use the 7/16"
nut driver included in the accessory kit to loosen the three locking bolts under the projector
platform.
Loosen these
three bolts.
14 Finalizing the Installation 99-00582-20 REV A0