Turn The System Part On (Part On Or Cmd 2) - Bosch D621 User Manual

Turn the System Part On (Part On or Cmd 2)

Exit Delay Time (to be filled in by your security company).
You have __________ sec. to exit premises before system turns on.
Part On turns on part of your system, leaving the rest of the system turned off.
Refer to the Point Identification section of your Command Center Reference Card
to identify Part points designated for Part On activation.
Once you press the Part On key, the exit delay timer begins. You should leave the
premises before the exit time expires. Leaving after exit delay expires starts an alarm
event.
1. Make sure Part points are normal (not faulted).
2. Press [PART ON]. The Command Center may prompt you to enter
a valid passcode by flashing the Cmd indicator.
3. Enter your passcode, if necessary. The Part On, Status, and Cmd
indicators light. If your system has a faulted point (door or window
open), you can either close it or bypass it (see Bypass Points).
During the exit delay, you may stop the system from turning on by
entering your passcode.
4. During the last 10 sec. of Exit Delay, the Command Center emits a
double tone every second to warn you not to exit and to turn the
system off. The system then turns All On. The All On indicator
remains on steady.
1 2 3 4
9 10 11 12 13 14 15 16
5. To turn the system off, enter your passcode.
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
5 6 7 8
D621 User's Guide
Page 15
All Status
Part Cmd
46840D