Delete A Passcode (Cmd 58) - Bosch D621 User Manual

Led command center d621
Hide thumbs Also See for D621:
Table of Contents

Advertisement

13. Enter the user number followed by the [*] key. (For example, press
[4] [*] to assign an authority level for User 4.)
14. Enter the authority level.
15. Press the [CMD] key until the Command Center emits a single beep
tone, the Cmd indicator turns off and the Status indicator turns on.
This indicates that the Command Center has exited this command.
The new user passcode, area assignment, and authority level are
automatically logged into the system's programming memory. Make sure
your security company's programming records are properly updated.
IMPORTANT

Delete a Passcode (Cmd 58)

Use this command to delete passcodes. This command requires the appropriate
authority level to delete passcodes.
You cannot delete your own passcode using this command. Only use this
feature under the direction of your security company.
IMPORTANT
1.
Make sure the system is turned off (All and Part indicators are off).
2.
Press [CMD] [5] [8]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3.
Enter your passcode. The available user numbers flash.
1
2
3
4
9 10 11 12 13 14 15 16
4.
Enter the user number you want to delete. (For example, press [2]
[*] to delete User 2). You cannot delete yourself as a user.
If the user does not exist in the system as set up by your security company,
the Command Center emits an error tone.
IMPORTANT
5.
Press [CMD] to exit this command.
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
5
6
7
8
D621 User's Guide
Page 27
Status
All
Part
Cmd
46840D

Advertisement

Table of Contents
loading

Table of Contents