Change Others' Passcode Level (Cmd 56) - Bosch D621 User Manual

Change Others' Passcode Level (Cmd 56)

Use this command to change passcode authority levels for each user in the system.
This command requires the appropriate authority level to change passcodes. You
cannot change your own passcode authority level. Only use this feature under the
direction of your security company.
The following should be filled in by your security company.
• Authority Level 1 includes these commands:
_________________________________________________________
• Authority Level 2 includes these commands:
___________________________________________________________
• Authority Level 3 includes these commands:
_________________________________________________________
• Authority Level 4 includes these commands:
_________________________________________________________
1. Make sure the system is turned off (All and Part indicators are off).
2. Press [CMD] [5] [6]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3. Enter your passcode. Point indicators 1, 2, and 3 flash.
1 2 3 4
9 10 11 12 13 14 15 16
4. Press [2] to change passcode authority levels. The available user
numbers now flash.
5. Enter the user number that you want to change the authority level
for, followed by the [*] key. (For example, press [3] [*] to change the
authority level for User 3). The user number now turns on solid.
If the user does not exist in the system, the Command Center will emit an
error tone.
IMPORTANT
6. Enter the new authority level (1 to 4) followed by [CMD].
7. The available user numbers flash. Select another user, or press
[CMD] twice to exit.
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
5 6 7 8
D621 User's Guide
Page 25
All Status
Part
Cmd
46840D