Turning On Part Of The System (Part On) - Bosch Security Systems User Manual

Hide thumbs Also See for Security Systems:
Table of Contents

Advertisement

Turning On Part of the System (Part On)

I have this feature.
I do not have this feature.
Part On turns on only a part of your system, leaving the rest of the system
turned off. Refer to the Point Identification section of your keypad's
reference card to identify Part points. Once you've pressed the [0] key, exit
delay time starts to count down. You should leave before exit delay time
expires. Leaving after exit delay expires causes an alarm event. Use Part On
when you want part of your system turned on.
1.
Make sure Part points are normal (not faulted).
2.
Press the [0] key. If all Part points are normal, exit delay time
begins. If your system has faulted points, you should return them to
normal, or refer to Bypassing Points (on page 16).
During exit delay, you may stop the system from turning on by
pressing [CLEAR]:
If you wish to, you can turn the system Part On with No Delay by
pressing the [0] key again:
If you wish to, you may bypass points by pressing the [ ] key. The
system prompts you through the procedure:
3.
When exit delay time expires, the keypad beeps three times and
then the system turns on.
4.
To turn the system off, enter your personal passcode.
30 SEC TO EXIT!
TO STOP
PRESS CLEAR
FOR NO DELAY
PRESS 0
TO BYPASS POINTS
PRESS
PART ON
SYSTEM OK
15

Advertisement

Table of Contents
loading

Table of Contents