Configuring Time Server Settings; The View Administrative Option - Avaya one-X Installation And Maintenance Manual

Configuring Time Server Settings

Use this procedure to designate a server for Simple Network Time Protocol (SNTP) and to set
corresponding values.
1. When you select SNTP... from the Admin Procedures Screen, the telephone displays the
following settings and prompts you to enter the IP Address of the SNTP server:
SNTP Server:
SNTP GMT Offset:
SNTP Daylight Savings Time:
2. To change a setting:
- If the field shows Right/Left Arrow indicators, press the Right (or Left) navigation arrow
to cycle through the available settings.
- If the field does not show Arrow indicators, press the appropriate softkey(s) and use the
dialpad to enter the new value.
3. Press Save to store the new setting and redisplay the Admin Procedures screen.

The View Administrative Option

If you are using static addressing and encounter problems, use the following procedure to verify
the current values of system parameters and file versions.
Note:
Unless otherwise prevented using administration, the user can view but not
Note:
change most of the parameters associated with Craft Local Procedures. For
more information about this option, see the applicable user guide(s).
Note:
If the View Network Information option is not available due to being disabled by
Note:
administration, use the ADDR option to view IP Addresses. See
Addressing Installation
incorrectly. Verify whether you were provided with correct IP Addresses.
Description/Example
IP address of the network time server.
Local time difference in hours from Greenwich
Mean Time, e.g., NJ is -5.
Indicates whether the telephone should
recognize Daylight Savings Time (DST)(0=no
DST, 1=DST activated as per DSTOFFSET,
2=.automatic based on DSTSTART and
DSTSTOP values.
on page 29. The IP Addresses might have been entered
Configuring Time Server Settings
Static
Issue 1 May 2007 39