Connecting Wires To Terminals - Kenwood DNX5350BT Quick Start Manual

Ñ Connecting wires to terminals (DNX5350BT, DNX5350DAB)
Ignition key
switch
Car fuse
box
(Main fuse)
Battery
To steering remote
To use the steering wheel remote
control feature, you need an exclusive
remote adapter (not supplied) matched
to your car.
To car light control switch
Connect to the terminal that is
grounded when either the telephone
rings or during conversation.
To use the Mute feature, you need to
hook up this wire to your telephone
by using a commercial telephone
accessory.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
of the film-type antenna.
(Max. 300mA, 12V)
When using the optional power
amplifier, connect to its power control
terminal.
28
ñ English
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse
Black (Ground wire) ¤
box
(To car chassis)
A
A
Light Blue/Yellow
(Steering remote control wire)
Orange/White
(Dimmer control wire)
Brown (Mute control wire)
Blue
(Antenna control wire)
Blue/White
(Power control wire)
If no connections are made,
do not let the cable come out from the tab.
Fuse (10A)
Accessory 1
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
ILLUMI
MUTE
ANT CONT
P. CONT
White/Black
+
White
Gray/Black
+
Gray
Green/Black
+
Green
Purple/Black
+
Purple
Speaker impedance: 4-8 Ω
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker