Connecting Wires To Terminals - Kenwood DNX9280BT Quick Start Manual

Connecting Wires to Terminals

Connector Function Guide
Pin Numbers for Cable Colour Functions
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White Dimmer
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
⁄
Speaker Impedance
: 4 – 8 Ω
26 | Quick Start Guide
Battery
Power Control
Ignition (ACC)
Earth (Ground)
Connection
Rear Right (+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
2WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Make sure
to make the proper connections to prevent damage
to the unit.
The default connection for the wiring harness is
described in 1 below. If the ISO connector pins
are set as described in 2, make the connection as
illustrated.
Please be sure to reconnect the cable as shown
2 below to install this unit to the Volkswagen
vehicles etc.
1 (Default setting) The A-7 pin (red) of the
vehicle's ISO connector is linked with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
Red (Ignition cable)
Unit
Yellow (Battery cable)
2 The A-7 pin (red) of the vehicle's ISO
connector is connected to the constant
power supply, and the A-4 pin (yellow) is
linked to the ignition.
Red (Ignition cable)
Unit
Yellow (Battery cable)
Red (A-7 Pin)
Vehicle
Yellow (A-4 Pin)
Red (A-7 Pin)
Vehicle
Yellow (A-4 Pin)