Connecting Wires To Terminals - Kenwood DNX890HD Quick Start Manual

Gps navigation system
Hide thumbs Also See for DNX890HD:
Table of Contents

Advertisement

Quick Start Guide

Connecting wires to terminals

Ignition key
switch
Car fuse box
(Main fuse)
Battery
To use the steering wheel remote
control feature, you need an exclusive
remote adapter (not supplied) matched
To car light control switch
Connect to the terminal that is
grounded when either the telephone
rings or during conversation.
To use the Mute feature, you need to
hook up this wire to your telephone by
using a commercial telephone accessory.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
Fuse (10A)
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse box
Black (Ground wire)
(To car chassis)
A
A
Light Blue/Yellow
(Steering remote control wire)
To steering remote
REMOTE CONT
to your car.
Orange/White
(Dimmer control wire)
Brown (Mute control wire)
Blue
(Antenna control wire)
(Max. 300mA, 12V)
Blue/White
(Power control wire)
If no connections are made,
do not let the cable come out from the tab.
28
Accessory 1
White/Black
White
Gray/Black
Gray
Green/Black
STEERING WHEEL
REMOTE INPUT
Green
ILLUMI
Purple/Black
Purple
MUTE
Speaker impedance: 4-8 Ω
ANT CONT
P. CONT
Fuse (10A)
To front left
speaker
+
To front right
speaker
+
To rear left
speaker
+
To rear right
speaker
+

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dnx570hdDnx690hdDnx5080exDnx5700bt

Table of Contents