Kenwood DNX5350BT Quick Start Manual page 22

Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring harness.
4) Connect the wiring harness wires in the
following order;
ground, battery, ignition.
5) Connect the wiring harness connector to the
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Press the <Reset> button. (P.4)
9) Perform the Initial Setup.
See First Step (P.6).
⿠DNX5350BT, DNX5350DAB
7 or 8
⿠DNX535VBT
Screws (included in
genuine audio unit)
✎
NOTE
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
22
ñ English
Car Bracket
Ñ Trim plate (DNX5350BT, DNX5350DAB)
1) Attach accessory 6 to the unit.
7 or 8
6