Connecting Wires To Terminals - Kenwood DNX570TR Quick Start Manual

Quick Start Guide

Connecting wires to terminals

Ignition key
switch
Car fuse box
(Main fuse)
Battery
To use the steering wheel remote
control feature, you need an
exclusive remote adapter (not
supplied) matched to your car.
To car light control switch
Connect to the terminal that
is grounded when either the
telephone rings or during
To use the Mute feature, you
need to hook up this wire to your
telephone by using a commercial
telephone accessory.
Depending on what antenna you
are using, connect either to the
control terminal of the motor
antenna, or to the power terminal
for the booster amplifier
of the film-type antenna.
When using the optional power
amplifier, connect to its power
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse
Black (Ground wire)
box
A (To car chassis)
A
Light Blue/Yellow
(Steering remote control
wire)
To steering remote
Orange/White
(Dimmer control wire)
Brown
(Mute control wire)
conversation.
Blue
(Antenna control wire)
Blue/White
(Max. 300mA, 12V)
(Power control wire)
control terminal.
If no connections are made,
do not let the cable come out from the tab.
Fuse (10A)
Accessory 1
Green/Black
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
ILLUMI
MUTE
ANT CONT
P. CONT
26
White/Black
To front
left
+
speaker
White
Gray/Black
To front
right
+
speaker
Gray
To rear
left
+
speaker
Green
Purple/Black
To rear
right
+
speaker
Purple
Speaker impedance: 4-8 Ω