Supplied Accessories - Kenwood DNX5350BT Quick Start Manual

• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or
fail to work if you share the ¤ wires or ground them to
any metal part in the car.
• When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example,
if you connect the ¢ connector of the left speaker
to a front output terminal, do not connect the ¤
connector to a rear output terminal.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Mount the unit so that the mounting angle is 30° or
less.
• This unit has the cooling fan to decrease the internal
temperature. Do not mount the unit in a place where
the cooling fan of the unit are blocked. Blocking
these openings will inhibit the cooling of the internal
temperature and result in malfunction.
Cooling fan
• Do not press hard on the panel surface when installing
the unit to the vehicle. Otherwise scars, damage, or
failure may result.
• Reception may drop if there are metal objects near
the Bluetooth antenna.
DNX5350BT
DNX5350DAB
Bluetooth antenna unit
DNX535VBT
Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1 [1][3]
3
(3.5 m)
5
[1][3]
7
(M5x6mm)
9
(3 m)
[3]
-
~ [3]
DNX5350BT only
[1]
[2] DNX535VBT only
[3] DNX5350DAB only
region code 2/3 area only
[4]
2 [2]
x1
4
x1
6 [1][3]
x1
[1][3]
8
(M5x7mm)
x6
[1][3]
0
x1
[3]
=
x1
! [3]
x3
English ñ
x1
x1
x1
x6
x1
x1
x1
21